In this guide, we are going to look at how to tie a Windsor Knot. The Windsor knot is a thick, wide triangular knot which promotes confidence. The Windsor knot is one of the smartest knots, and is usually worn to interviews and on smart uniform. Hence we use it in the ATC. We wear ties only in our light blue, wedgewood shirt, or in the band.
Follow the steps to learn how to tie a proper Windsor knot.
First of all, ensure that your collar is up. This makes it easier to tie the knot. Take a look at the diagram on the left. “W” stands for wide and “N” stands for narrow. Take the “W” part of the tie and place it around your dominant side (the side you use to write or play sport.). Allow enough length in the “W” side for the tie to reach your belt buckle. Cross the “W” part over the “N” part of the tie.
Hold the point where “W” crosses over “N” and pull the “W” end towards your chest and up between your collar and the cross.
Pull the wide end “W” underneath narrow end “N” and to the left, back through the loop and to the left again so that the wide end “W” is inside out.
Bring the “W” end of the tie across to the right.
Bring the “W” end behind the tie and back up through the loop.
Pull the “W” end down and through the knot you just created
Using both hands, one on each Tighten the knot and pull it up towards the collar.
If the “W” part of the tie is too short or too long, untie the tie and start again with the “W” part of the tie in a more suitable position.
When taking off and untying the tie, follow these steps in reverse order. This is to prevent the tie from distorting.
If you still cannot tie a windsor knot, ask one of your NCO’s to help
