I often install beadboard to the sides of built-in cabinets in addition to using it as a decorative element on walls ceilings. The most cost effective beadboard material I have found is 4×8 paneling sheets found at most home improvement stores. If 8′ isn’t tall enough, you have to install multiple pieces and the seam is pretty obvious. Generally I plan to hide the seam with trim but there are occasions that I just want seamless beadboard. It requires a bit of work to hide the seam, but it is possible.
1. Make sure beads and grooves line up
When installing multiple pieces of beadboard vertically, the most important thing is that the grooves and beads line up as perfectly as possible. There can be a difference from one sheet to another so take some time to select beadboard panels that match.
2. Attach beadboard firmly to surface
When attaching beadboard to the cabinet, wall or other surface, in addition to nails, use caulk as adhesive. It may not be necessary to use adhesive on the entire panel, but apply it on the area where the seam is being created. The objective is to prevent future movement and cracking in the wood putty and reveal the seam.
Make sure the beads and grooves line up as perfectly as you can get them and drive nails wherever you need them to pull the panel flat against the surface.
3. Apply wood putty
Apply your favorite wood putty generously, making sure topress it into the grooves. In order to build up a strong patch over the seam, spread on an ample supply of wood putty. Then use a wide putty knife to feather it out, sreading a portion of putty both above and below the seam. Feathering it out and spreading the wood putty over a larger area will help hide the seam.
4. Clean wood putty out of grooves
Use the corner of a putty knife to scrape the putty out of the grooves. In some areas you may find that this action reveals the seam. If this happens, reapply putty in that area and take less out when scraping the groove. You may have to use your fingers to shape and round the wood putty over the beads.
5. Sand face and grooves
Face
Wait for the putty to be completely dry before sanding. The flat face of the beadboard can be sanded with a fine grit sanding block or using an orbital sander. Either way, use gentle pressure and only take off a little at a time so you don’t remove too much putty and reveal the seam.
Beads and Grooves
I like to wrap a putty knife is sandpaper to create a thin, stiff, and flat sanding block. (I start with 120 grit sandpaper followed by 220 grit.) Using a gentle up and down motion, sand all the beads and grooves. You’ll probably have to reposition the sandpaper frequently because there is such a small area of sandpaper surface being used.
6. Decide if you can move forward or need to repeat a few steps
Once the whole seam is sanded smooth, look at it with a critical eye from multiple directions. Decide if it looks really good or needs another coat of wood putty. If it needs another coat, go back to step 3 and repeat.
7. Prime
If it looks great, prime it. The primer will accentuate any and all imperfections. If any imperfections are revealed that you don’t want to live with, repeat the necessary steps to hide the seam to standards you can live with.
8. Paint
Once you decide the hidden seam looks great, go ahead and paint the beadboard.
Tip: If after painting you see a visible hairline crack, scraping the paint with a one sided razor blade might do the trick. Hold the blade at close to a 90 degree angle and gently scrape across the crack/seam. If the first pass doesn’t do anything try again with a little more pressure. This trick only works with very small seams.
If you’re still not happy with the hidden seam, you can keep perfecting it until you’re happy with it.